menu_book Explore the article's raw data

A simple and rapid external standard calibration HPLC method for determination of lumefantrine in dried blood spot samples from malaria patients in Botswana

Abstract

A simple external calibration liquid chromatography-diode array detector method was developed, validated, and applied for the determination of lumefantrine (Lum) in dried blood spot (DBS) samples collected from malaria patients in Botswana. The samples were validated in accordance with the United States Food and Drug Administration guidelines for bioanalytical methods after sample preparation using solid-liquid extraction. Separation was achieved using an XTerra C18 column (50 x 4.6 mm, 5 mu m), and a binary solvent system of acetonitrile and water adjusted to pH 2.3 was used as the mobile phase. The validated method was applied for the determination of Lum in DBS samples collected from malaria patients infected with Plasmodium falciparum in Botswana. The calibration curve was linear between 0.5 and 12 mu g/mL with a coefficient of determination (R-2) of 0.9996. The limit of detection and the lower limit of quantification were 0.5 and 1.4 mu g/mL, respectively. The efficiency of extraction measured as percentage recovery ranged between 84.2% and 107.8% at the three quality control (QC) levels, that is, low QC, mid QC, and high QC. In conclusion, data suggest that the method is suitable for the determination of trace Lum in biofluids and can also be used for therapeutic drug monitoring and pharmacokinetic profiling.

article Article

date_range 2024

language English

link Link of the paper

format_quote

Brooks Blondie

Paganotti Giacomo

Massele Amos

Sepako Enoch

Adiukwu Paul

Sichilongo Kwenga

Sorry! There is no raw data available for this article.

Loading references...

Loading citations...

Featured Keywords

dried blood spot

HPLC

LLOQ

lumefantrine

malaria

shopping_basket PURCHASE DATA

Assessment of reinforced concrete building damages following the Kahramanmaraş earthquakes in Malatya, Turkey (February 6, 2023)

Abstract

Earthquakes of magnitude Mw = 7.7 and Mw = 7.6 hit the city of Kahramanmaraş (Turkey) on 6 February 2023. These earthquakes caused serious damage in 11 provinces in Turkey resulting in over 50,000 deaths and huge economic losses with the collapse of thousands of buildings. Two consecutive devastating earthquakes have severely damaged the reinforced concrete building stock located in Malatya. There are many reasons reinforced concrete structures suffer damage under the influence of seismic loads. These reasons can be listed as material and section properties that do not comply with earthquake codes, workmanship defects, ground parameters that are not considered and design errors, as seen in field investigations after earthquakes in Turkey in the past. In this research, a field study was conducted on reinforced concrete buildings damaged after the earthquakes in Malatya province. The causes of structural damages in reinforced concrete buildings between 6–26 years of age were assessed in terms of design and material defects. The structural damages were mainly caused due to insufficient stirrups in structural members, short column, strong beam–weak column, failures of infill walls, soft story type collapse, poor concrete quality, and reinforcement corrosion. In addition to the field investigation, the spectrum relationships created using raw acceleration data obtained from DEMP (Disaster and Emergency Management Presidency) stations in Malatya province were compared with the design response spectra.

article Article

date_range 2024

language English

link Link of the paper

Collapsed buildings

Example 1 (jpg)